1. Qwiek support
  2. Qwiek.up
  3. Safety and product specifications

Safety instructions and technical specifications for Qwiek.up

This document contains the safety instructions for the Qwiek.up. These instructions are also found in the Qwiek.up manual.

General

 
  • QU-technische specificaties handleidingImportant instructions for use are provided. Please read these safety instructions/manual carefully before using the Qwiek.up.
  • Before plugging the Qwiek.up into the power outlet, ensure that the required power supply matches the mains voltage. You can find this information on the product label, located on the left leg of the Qwiek.up, under 'Power Supply'.
  • Allow the Qwiek.up to cool for 2 to 5 minutes after use before moving it.
  • The Qwiek.up uses a projector. Hard shocks or impacts can damage the projector lamp. Therefore, always handle the Qwiek.up with care and avoid shocks (e.g., when passing thresholds or moving the Qwiek.up over (outdoor) tiles).
  • Do not look directly into the light of the projector lamp when the Qwiek.up is turned on. The bright light can damage your eyes.
  • Do not block the light of the projector lamp when the Qwiek.up is turned on. This can cause the Qwiek.up to overheat, leading to melting of the material, potential fire hazards, and burns to people.
  • Ensure that no liquids or foreign objects enter the Qwiek.up. These can come into contact with dangerous voltage points and cause short circuits in the components, leading to fire or electric shock. Immediately switch off the Qwiek.up if it becomes wet or moist, or if foreign objects enter the Qwiek.up.
  • Do not use the Qwiek.up if it is physically damaged or deformed. Physical damage or deformation can be caused by falling, opening, disassembling, bending, piercing, burning, deforming, crushing, painting, or heating the device.
  • After using the Qwiek.up, check if it has cooled down sufficiently before unplugging it from the power outlet. As long as the indicator light on the Qwiek.up keeps blinking, it is still in the process of cooling down.
  • QU-technische specificaties elektriciteitWarning! Hazardous electrical voltage inside the Qwiek product casing.


Placing

  • To reduce the risk of electrical shock and fire, do not use the Qwiek.up in the following conditions:
    • In damp environments
    • In areas that are prone to excessive dust and dirt
    • Near devices that generate a powerful magnetic field
    • In direct sunlight
  • Do not use the Qwiek.up in places where flammable or explosive gases may be present, as the projector lamp produces a high amount of heat that can ignite these gases.
  • Always transport the Qwiek.up in an upright position, such as when projecting onto a ceiling, to prevent it from falling over and getting damaged.
  • Never store the Qwiek.up in extremely hot, cold, or moist environments. The ambient temperature should be between 5-40 °C, with a relative humidity of 10%-85%.

Ventilation

  • Ensure proper ventilation by keeping a clearance of half a meter around the Qwiek.up, especially on the sides.
  • Never place any objects, such as a box, on top of the Qwiek.up while it is in use.
  • Avoid blocking the ventilation openings of the Qwiek.up as this can cause overheating and damage to the surroundings.

Maintenance and Repairs

  • Never remove the device's casing to prevent electrical shock.
  • For maintenance and repairs, always seek assistance from a Qwiek staff member.

Warranty Conditions

You can find the warranty conditions of Qwiek products on our website at www.qwiek.eu/warranty-conditions.

Disclaimer

Our disclaimer applies to this Qwiek product. You can find it at www.qwiek.eu/disclaimer.

Product Specifications

Dimensions (LxWxH): 43 x 43 x 84 cm


Weight: 29 kg


Power Supply: 100-240V~, 50/60Hz, 2.0A


Maximum Power: 250 Watts


Light Output: 3700 ANSI Lumens


Waste disposal instructions (WEEE guidelines)

QU-technische specificaties afval

Do not dispose of this electronic device in the trash when you no longer need it. Instead, take it to an organization that specializes in recycling technical equipment to minimize its impact on the environment.

CE conformity declaration

We, Qwiek BV, declare that the Qwiek.up v7 complies with the essential guidelines of the Low Voltage Directive - 2014/35/EU, Electromagnetic Compatibility Directive (EMC) - 2014/30/EU, Radio Equipment Directive (RED) - 2014/53/EU en Restriction of Hazardous Substances in Electrical and Electronic Equipment (RoHS) - 2011/65/ EU. If desired, a signed declaration of conformity can be requested from Qwiek.